View Single Post
  #18 (permalink)  
Old 02-25-2007, 08:41 PM
JTW37's Avatar
JTW37 JTW37 is offline
Metal Finishing Guru
Caswell Platinum Member
 
Join Date: Feb 2006
Location: Bristol, In
Posts: 600
JTW37 is an unknown quantity at this point
Default Re: Any ideas for a door latch?

Well, after fighting the ice that was everywhere, I made it to Lowe's. What a waste of time. Even stopped at ACE hardware and the same story. I think I may try one of the local Hardware Stores that is not a chain and see what they have. Then there is TSC that is a farm supply store. Maybe something there. If not, I've built most everything for this oven, guess I can made the latch too.

Reworked the hinges today, as I didn't much care for the way the door was acting. It shuts better and more flat. Found I had a little bit of binding going on.

Tomorrow will be busy doing a three duce manifold and gas tank for another. Plus work on the oven as much as I can.
__________________
Who says you can't teach an ole dog new tricks?
Reply With Quote