Quote:
Originally Posted by 54PANMAN
hi yall im kinda new here, i've gone through this site dozens of time read & search out tons of post and am asking my first Q: so......... i've been putting off polishing some smaller parts due to the tight working spaces on the part! and now i have got to get them done so my Q: is what do you all use to sand down small parts like little carbs, i saw some folks polishing 38m mikunis.... right now im working a jet ski intake (cast alum) and it it takining forever!!!! small part, tight areas, small raduis curves etc.... are there special dremal bits or  thank panman |
I use cartridge rolls and felt bobs with greaseless a lot. Do a search...this question is asked almost once a week.