Lead Sheet for Cathode. Thickness Matter?

[pbwrx]

Getting set up for my first run. Been lurking a lot and reading practically the entire forum! Thanks for all the help so far from everyone

One question - I have the chance to pick up a 3/32 lead sheet 34 x 48" for $90. Would this be too thin for a cathode?

[acidrain]

3/32 is more than enough... the lead is not affected by the acid and will last forever.

[pbwrx]

Thankyou I figured it was too good a deal to pass up but wanted to make sure I wasn't hosing myself in any way.

Now to start plumbing the agitation system while I wait for the auction for my Little Giant pump to end. Back to the hardware store I go!

[DefiantK]

Now to start plumbing the agitation system while I wait for the auction for my Little Giant pump to end. Back to the hardware store I go!

Off topic abit but is the seller trader drew? If so I'd avoid it all cost, shipped me a new in cox pump that had a broken impeller, damaged housing and cracked impeller shaft.

[pbwrx]

No that's not his ebay name. Thanks for the warning though.

Schedule 40 PVC is fine for the anno tank, right?

[sswee]

Schedule 40 PVC is fine for the anno tank, right?

Yes, PVC or CPVC sched.40 is fine.
SS

[pbwrx]

Many thanks guys.

Got the pipe and the Rubbermaid. Won the auction for the pump for $30! For that price even if it works for a little while I'm happy.

Sadly the source I had for my lead sheet fell through. I found some on rotometals - would 1/64th be too thin?

Many thanks again.