|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
09-20-2003, 10:37 PM
|
|||
|
|||
Smutty
A ? for all that has input on this. I am getting a lot of parts That come out of the dye beautiful but after sealed and dried they have a smutty, grayish cast to them. I am using low temp sealer. Any input is appreciated. Thanks
|
|
09-26-2003, 11:40 AM
|
|||
|
|||
|
do you use distilled water for all of your steps? I've found that the high calcium content in my water will cause a dull finish, especially if I use it for sealing. (however, I only use boiling water to seal.)
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| alum. turned a smutty gray (Electroless Chrome) | dogwooddir | Electroplating Questions | 0 | 09-11-2004 10:45 AM |
Linear Mode
