|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
03-14-2006, 08:27 PM
|
|||
|
|||
battery acid mixture
I have a CASWELL LCD system that I'm setting up. The CASWELL manuel says to mix the battery acid at a 3 part distilled water to 1 part acid, I have read elswhere that you should use a 1 to 1 mixture, which is the proper mixture to use? I have a used Astron VS-35m power source that I plan to use on my 5-gal set-up.
|
|
03-14-2006, 08:52 PM
|
||||
|
||||
Re: battery acid mixture
A 1:3 ratio (battery electrolyte : distilled water) is the correct ratio for LCD anodizing. It will work for CD's up to 12A per square foot. A 1:2 or 1:1 ratio is for higher amperage anodizing or used in the past by many using the let it rip method. Using them below a 12A CD will cause dissolution problems among others. Last edited by sswee; 03-14-2006 at 08:55 PM.
|
|
03-14-2006, 11:08 PM
|
|||
|
|||
|
Re: battery acid mixture
Thanks for the clarification.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Acid | SniperSlayer | Anodizing Questions | 8 | 07-25-2005 09:59 PM |
| where do i get battery acid for my copper kit | plater12 | Electroplating Questions | 1 | 07-17-2004 08:49 PM |
| % Sulfuric in Battery Acid? | jime | Electroplating Questions | 3 | 01-26-2003 07:35 AM |
| Acid for anodizing | desert_roamer | Anodizing Questions | 5 | 07-25-2002 09:10 PM |
| Battery Acid. | ketanjajal | Electroplating Questions | 1 | 03-05-2002 09:27 AM |
Linear Mode
