|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
03-15-2006, 09:56 PM
|
|||
|
|||
Surface Area Dimensions
OK, I'll start this out...
Please post any common SA dimensions you may have. Here is mine. These are paintball gun parts. I''ll add to it as I get more info. All dimensions are welcome... not just paintball gun stuff! 
__________________
Specializing in anodized graphics in Paintball guns. Last edited by acidrain; 03-15-2006 at 10:17 PM. 
|
|
03-15-2006, 10:45 PM
|
|||
|
|||
|
Re: Surface Area Dimensions
My mesurments for an 05 Stock ego:
Body: 69.74" Gripframe: 49" ramtube: 16.91" (doesnt seem right, should be more) lpr housing: 8.3" Reg ASA(part that says "EGO" on it: 5.3 Frame tag(can't rember where this peice goes): .5" oops rail: 5.345" Eye covers: 4.125 for a pair Stock non lever feedneck: 8.84" on/off knob: 3.7 (guys, any idea of what to do to protect the pin? cuz now i just have part of a nail in there) HPR Upper: 10.75 Stock trigger: 2" Barrels: Freak tip 14"(part 9.5" in length):43.5 Keep um comming! dont be afraid to double check any of thease values, they are just what I caculated, and are probily wrong. USE AT YOUR OWN RISK
|
|
03-15-2006, 10:48 PM
|
|||
|
|||
|
Re: Surface Area Dimensions
acid rain, you should specify what model/ what year part are, because milling changes a bunch from gun to gun, and year to year. If you need any help IDing parts, I have a pretty good knolage of paintball guns, and could help you out.
|
|
03-16-2006, 10:49 AM
|
|||
|
|||
|
Re: Surface Area Dimensions
Hmmm... moved my pic, and tried to edit my post, but can't figure that out. Am I missing something?
I'll work on the model/year info, and I have more to add (when I can). As for the on/off... all on/offs come apart. Usually they unscrew (with heat to break the loc-tite), but I believe on the EGO, the pin is pressed in. Here is the pic again: 
__________________
Specializing in anodized graphics in Paintball guns.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculating Surface Area, the Easy Way. | PrecisionPB | Anodizing Questions | 6 | 05-28-2005 02:56 PM |
| Anodizing without knowing surface area? | sbpoole | Anodizing Questions | 3 | 01-06-2005 07:09 PM |
| Surface area measurements | rwizinsky | Anodizing Questions | 0 | 12-20-2003 05:11 PM |
| surface area for electroless plating | tepece | Electroplating Questions | 1 | 02-09-2003 07:54 PM |
| Surface Area vs. Current | shorton | Electroplating Questions | 3 | 11-06-2002 11:36 AM |
Linear Mode
