Caustic Soda Etch - Page 2 - Plating Powder Coating Buffing Anodizing

yoyoboy · #11 (**permalink**) 04-01-2006, 12:29 PM

I've never had good luck with baking soda, it always leaves white blemmishes

Sid03 · #12 (**permalink**) 04-02-2006, 10:57 AM

I have always used baking soda. I have had a couple times when I had some weird results that I never could figure out, but usually I have good results.

I may ano something, the dunk in rinse tank, then dunk in baking soda tank to see if the rinse alone is getting the acid off the parts well enough.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What to replace sand with (blasting) ?	rclint	Metal Polishing Questions	10	07-07-2007 12:09 PM
Questions after first run	cameraman	Anodizing Questions	12	10-19-2005 02:11 PM
Acidic alternative to caustic anodize stripping	redback	Anodizing Questions	6	08-02-2005 06:11 AM
etch....desmut.....deoxidize.........weeeeeeeeeeeeeee	Sid03	Anodizing Questions	8	02-19-2005 01:05 AM
etch....??	Sid03	Anodizing Questions	2	09-03-2004 08:31 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)