|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
09-09-2006, 05:25 PM
|
|||
|
|||
Re: thick coatings
Hi sswee,
Thankyou for your reply and the great info but do you still use the 3to1 ratio for acid? And just for the record I think the putters look fantastic great stuff and I think 60degrees tank temp should be easy to achieve here in rainy old england as the winter will be here soon and its prob going to be a cold one ha . Best Regards to you Rick. 
|
|
09-10-2006, 12:06 AM
|
||||
|
||||
|
Re: thick coatings
Yes I still use the 3:1 ratio. Fibergeek and neilf tested its use up to current densities well beyond what I'll run due to power requirements. The only reason to go to a closer ratio would be to get resistance down in the circuit to lower the voltage demand but then you have to contend with an acceleration of dissolution. It's all a balancing act.
If your winter is as cold as mine last year, you'll need heaters to get it up to 60 degrees. SS
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1mil thick or less whats the results? | rick201 | Anodizing Questions | 2 | 07-14-2006 12:49 AM |
| Problems with thick metal | chromeitout | Powder Coating Questions | 5 | 05-30-2006 04:59 PM |
| Ceramic Coatings. aka Jet-Hot | Fireblade | Powder Coating Questions | 13 | 04-19-2004 09:57 PM |
| BN piston skirt coatings | FF | Electroplating Questions | 0 | 02-19-2004 11:56 PM |
Linear Mode
