|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
09-19-2006, 01:54 PM
|
|||
|
|||
Re: Anodizing power supply recomendations
A computer PS is way too small. You need a current controlled unit that delivers at least 20v at calculated amps. Have you read up on how to anodize? Check the 720 rule discussion thread stickied at the top of the page for how to calculate required amperage.
__________________
Specializing in anodized graphics in Paintball guns. Last edited by lcaswell; 09-20-2006 at 09:30 PM. 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building power supply from manual | dfarning | Other Metal Finishing Questions | 0 | 02-19-2006 11:56 AM |
| power supply | Techno | Electroplating Questions | 0 | 09-20-2005 08:58 PM |
| anno power supply | jasonboulanger | Anodizing Questions | 2 | 01-07-2005 05:48 PM |
| Power supply | aalamo | Electroplating Questions | 5 | 11-24-2004 09:21 AM |
| Anodizing Power Supply Q's | jnbsystems | Anodizing Questions | 7 | 10-02-2003 10:33 PM |
Linear Mode
