![]() |
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
![]() |
|
|
Thread Tools | Display Modes |
|
|||
|
I found this on Ebay and was curious to see if anyone knows if this is a good rectifier. I would like to purchase a caswell unit but the 5 amp unit is too small and the 20 amp is overkill for the size of parts i wanna do. What do you pros think ?
http://cgi.ebay.com/10AMP-Gold-Plati...QQcmdZViewItem |
|
|||
|
Looks like a nice unit, but I'd go with this one: http://cgi.ebay.com/MASTECH-DC-POWER...QQcmdZViewItem
__________________
Specializing in anodized graphics in Paintball guns. |
|
|||
|
Or if you're a do it yourself type, and know electricity/electronics...
You could try here: http://www.uoguelph.ca/~antoon/circ/ps3010/ps3010a.html It seems to be a good functional supply, with good design and instructions. The best I've found in a few weeks of casual looking. |
|
|||
|
Stay as far away from that seller "findingking" as you can. The only negative feedback on eBay I have is because of them. I bought an item with Buy it now. Paid with Paypal within minutes. I waited and waited for the item 4 weeks later I finally get it after NO replys to any of my emails. So I open the package to find part of it was missing...email after email and nothing weeks go by and them the rest finally shows up. I left them feedback stating poor communications. Within 10 minutes they left me negative feedback too! Go figure!
LAter, Tim |
|
|||
|
Dont go with this little 3amp (Mastech HY1803D) one that I got. It starts to overheat after an hour at 1.5 amps and then it will not hold the amps steady anymore. It started bouncing from .7-2.0amps pretty quicky.
I would recommend a 10 amp unit. |
|
|||
|
Findingking is still around?....LOL Try looking them up, they don't even have a store front. They are a power seller on Ebay so don't expect Ebay to take your side. Always check a sellers feedback before you do business with them. If it smells like a fish....
On a positive note, ordered a 30volt 6amp Mastech rectifier today. |
![]() |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is the 20 amp CC rectifier big enough for this? | bbqboyee | Anodizing Questions | 4 | 04-01-2005 03:23 PM |
| CC Rectifier | PeterM | Anodizing Questions | 3 | 09-23-2004 07:09 AM |
| Rectifier Question | danahenderson | Anodizing Questions | 2 | 03-09-2004 05:57 PM |
| My rectifier died :( | SS65 | Electroplating Questions | 1 | 03-22-2003 07:01 PM |
| [b]Epsco 3 AMP Rectifier and Copy Chrome[/b] | gwjohnso | Electroplating Questions | 1 | 03-08-2003 11:11 AM |