|
|
|||||||
| Notices |
| Anodizing Questions Discussion board for anodizing questions. |
 |
|
|
Thread Tools | Display Modes |
05-15-2008, 02:20 PM
|
|||
|
|||
Re: Power Supply Question
Hmmm... I don't see that they are current controlled. You want CV/CC. Maybe a quick ph call just to make sure. Also, I suggest something higher that 15v.
__________________
Specializing in anodized graphics in Paintball guns. 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power supply question | jabe421 | Anodizing Questions | 1 | 05-08-2008 06:55 PM |
| On going power supply question?? | MrPontiac | Electroplating Questions | 9 | 11-14-2007 12:01 PM |
| Power supply follow up question: Attention Fibergeek | Gabourie | Electroplating Questions | 7 | 09-25-2004 08:53 PM |
| Power Supply Question | edwin247 | Anodizing Questions | 5 | 08-30-2004 11:20 AM |
| cheap powdercoating heater/chrome power supply question | dagobert | Electroplating Questions | 0 | 06-01-2004 11:59 AM |
Linear Mode
