|
|
|||||||
| Notices |
| Copy Chrome Kit Customers Only A dedicated forum for owners of our general Copy Chrome and Wheel Copy Chroming Kit. |
 |
|
|
Thread Tools | Display Modes |
07-16-2008, 08:12 PM
|
|||
|
|||
Power Supply Question
Would this power supply from ebay be enough to to plate up to 16" rims, MASTECH VARIABLE DC POWER SUPPLY 0-30 VOLTS @ 0-10 AMPS - eBay (item 140234470212 end time Jul-18-08 15:52:15 PDT)
Its 0-30volts, 0-10amps. They have one that goes up to 50amps but its $500 and I got under $200 to spend on a PS. Maybe I'll try to find a used one. Copy Chrome is 32sq inches per amp correct? 
|
|
07-17-2008, 10:50 PM
|
|||
|
|||
|
Re: Power Supply Question
Well I hope my parts won't exceed 84-86sq in because I bought a 0-30v @ 0-6amp Mastech power supply for 140 shipped, $60 bucks less than the 10 amp one. Hopefully this will be good enough for the three gal kit before I make any major investment.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Supply Question | Grumple | Anodizing Questions | 10 | 05-15-2008 02:20 PM |
| Power supply question | jabe421 | Anodizing Questions | 1 | 05-08-2008 06:55 PM |
| On going power supply question?? | MrPontiac | Electroplating Questions | 9 | 11-14-2007 12:01 PM |
| Power supply follow up question: Attention Fibergeek | Gabourie | Electroplating Questions | 7 | 09-25-2004 08:53 PM |
| Power Supply Question | edwin247 | Anodizing Questions | 5 | 08-30-2004 11:20 AM |
Linear Mode
