|
|
|||||||
| Notices |
| Electroplating Questions Discussion Board For Electroplating and Electroless plating. |
 |
|
|
Thread Tools | Display Modes |
01-07-2004, 02:38 AM
|
|||
|
|||
Anode Holder
Hi everyone.
Merry Chrismas and Happy New Year to all platers and their families. Simple (hopefully) question: I go through quite a few zinc anodes with my 12 gallon Copy Cad setup, what would be a suitable material to make an anode holder. I just want to slide in a new anode when one is needed. Basically, the setup has to accept a new 4X8 zinc sheet with no drilling, thus ensuring that all of the anode is used. Would stainless be OK if submerged in solution as a conductor only? Thanks. Andrew. 
|
|
01-15-2004, 06:56 AM
|
||||
|
||||
|
Anything on the 'anode' side of the tank MUST be made of anode material, otherwise it will sacrifice itself, just as the anode does. You will then contaminate the solution.
__________________
-- Mike Caswell Caswell Inc http://www.caswellplating.com Need Support? Visit our online support section at http://support.caswellplating.com Have A Web Site? Why not join our affiliate program and earn 15% of all sales. Join at http://www.caswellplating.com/affiliate.htm
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anode placement? | phunkmastakrez | Electroplating Questions | 2 | 09-30-2005 03:17 AM |
| Cleaning Nickel Anode | jmerson | Electroplating Questions | 1 | 12-17-2004 12:01 AM |
| Anode size to part ratio | mdarr | Electroplating Questions | 1 | 07-24-2003 03:20 PM |
| Gold anode | chromo | Electroplating Questions | 1 | 01-29-2003 02:19 AM |
| Anode positioning | 68goat | Electroplating Questions | 2 | 01-26-2003 09:56 AM |
Linear Mode
