|
|
|||||||
| Notices |
| Electroplating Questions Discussion Board For Electroplating and Electroless plating. |
 |
|
|
Thread Tools | Display Modes |
05-09-2004, 07:07 PM
|
|||
|
|||
noob questions
Triple chrome plating system
I see that some of the anodes contain lead.Would I be able to use pure lead sheets for plating purposes?If yes ,what is the optimal thickness? Also ,I see that it is recomended to remove the anodes and store after use.What about the heaters and pumps?Can I leave them in? What is the going rate for chrome these days?What do most shops charge by square inch ,or what is the consumption cost of the chemicals? I haven't even got my system online ,let alone have a technique yet and I already have people wanting chrome so I'll prolly be posting a lot ,discoveries and questions.Thanks for any help and good plating all 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Questions about masking and plugging and rectifiers, noob | Paintbalaguy | Anodizing Questions | 5 | 07-18-2005 08:28 PM |
| Some newbie questions... | kiwijetpilot | Anodizing Questions | 16 | 03-12-2005 08:18 PM |
| Noob ? about cure temps | jsyi | Powder Coating Questions | 3 | 07-01-2004 01:37 AM |
| A few newbe questions | thestormfamily | Electroplating Questions | 4 | 06-30-2004 08:54 AM |
| a bunch of questions | spectraflamed | Electroplating Questions | 1 | 04-04-2002 11:53 PM |
Linear Mode
