|
|
|||||||
| Notices |
| Electroplating Questions Discussion Board For Electroplating and Electroless plating. |
 |
|
|
Thread Tools | Display Modes |
08-02-2004, 12:07 PM
|
|||
|
|||
Plug-n-Plate Question
Hi everyone,
I am trying to achieve the Black Chrome effect on some die-cast drum parts. I purchased a Copper/Nickel combination Plug-n-Plate kit through Caswell, and did receive good support from the company via telephone. I was told to apply a flash copper layer, then a nickel layer, then the Black Krome. The original lug was brass coated, but I stripped this off the outside of the part (the lug is hollow). The flash copper went on very well, but I cannot get the nickel to go over the flash copper. Can anyone help me? Any advice will be greatly appreciated. Sincerely, Joe Migliaccio 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plug n Plate Gold over Sterling | novenarosary | Electroplating Questions | 0 | 03-12-2004 10:00 PM |
| Plug n Plate | lphurley | Electroplating Questions | 3 | 09-23-2003 12:15 AM |
| Question about plug and plate. | tomg552001 | Electroplating Questions | 1 | 05-15-2003 12:06 AM |
| Plug N Plate Question | carmelmike | Electroplating Questions | 1 | 03-20-2003 06:10 PM |
| Plug N Plate Copy Chrome question | Great_Scott | Electroplating Questions | 5 | 03-20-2002 05:53 PM |
Linear Mode
