power requirements for Fast Gold - Plating Powder Coating Buffing Anodizing

jomida · #1 (**permalink**) 01-15-2003, 08:36 PM

Through my job, I have access to a variety of DC power supplies. What current and voltage recommendations would you make for brush plating with Fast Gold?

Thanks

mcaswell · #2 (**permalink**) 01-15-2003, 09:30 PM

2-4 volts and 0.003 - 0.007 amps per square inch (when tank plating)

jomida · #3 (**permalink**) 01-15-2003, 09:34 PM

Is it the same for brush plating?

mcaswell · #4 (**permalink**) 01-15-2003, 10:51 PM

Sort of....the volts are the same, but the amps don't apply. You want to start at 2 volts and increase until it starts plating.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gold Plating and Nickel plating	tzmandevil	Electroplating Questions	2	09-16-2005 09:11 AM
How about Gold on Gold ?	Ra	Electroplating Questions	5	10-12-2004 07:47 PM
Power Supply Requirements	KomaToast	Electroplating Questions	1	02-26-2004 11:19 PM
Silver polish on 24k gold plate??	chromo	Electroplating Questions	3	04-07-2003 05:14 AM
plating and size power?	chromo	Electroplating Questions	7	01-18-2003 02:52 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)