|
|
|||||||
| Notices |
| Electroplating Questions Discussion Board For Electroplating and Electroless plating. |
 |
|
|
Thread Tools | Display Modes |
02-06-2003, 12:43 AM
|
|||
|
|||
HELP: NEW USER-MOLDINGS-EMBLEMS
WHAT TYPE OF METAL WAS USED FOR EMBLEMS IN THE 60'S. WHAT TYPE OF PLATING IS ON THOSE EMBLEMS ? WHAT TYPE OF PLATING WAS USED ON THE DOOR MOLDINGS, HEADLIGHT EYEBROWS, ROOF DRIP RAILS ETC. IS IT ZINC, POLISHED STAINLESS ? CAN SOMEONE PLEASE HELP ME OUT
|
|
02-06-2003, 01:37 PM
|
||||
|
||||
|
They're probably pot metal castings.
Your other questions are much too general for anyone to answer. Perhaps if you posted make, model numbers etc., someone might be able to help.
__________________
-- Mike Caswell Caswell Inc http://www.caswellplating.com Need Support? Visit our online support section at http://support.caswellplating.com Have A Web Site? Why not join our affiliate program and earn 15% of all sales. Join at http://www.caswellplating.com/affiliate.htm
|
|
04-22-2003, 01:48 PM
|
|||
|
|||
|
moldings, emblems
Depends on what make of car we are talking about. Most GM cars used anodized aluminum for grills and side moldings in the 60s. Trim around the front and rear glass was usually stainless steel.Emblems were mostly chrome plated.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| metal coating by chemical grafting need to find current user | jsullivan | Other Metal Finishing Questions | 0 | 06-02-2003 11:52 AM |
| Black Chrome for Emblems? | Z33al | Electroplating Questions | 3 | 03-23-2003 12:36 PM |
| New user with polishing questions...... | jisu009 | Metal Polishing Questions | 2 | 01-04-2003 02:05 PM |
| aluminum moldings | jose | Metal Polishing Questions | 3 | 02-15-2002 01:59 AM |
Linear Mode
