|
|
|||||||
| Notices |
| Electroplating Questions Discussion Board For Electroplating and Electroless plating. |
 |
|
|
Thread Tools | Display Modes |
04-01-2007, 09:26 PM
|
|||
|
|||
Bumps on Zinc Plate
I have been having an issue with my zinc plating lately. I am getting small bumps on the part I am plating. I am pretty sure the source of the bumps is chunks breaking off of the anode and landing on the part. One observation is that they only land on the top side of the part and never on the bottom. Any suggestions on how to solve this problem? I have been operating the bath at 110oF, plating at 120-140 ma/sqin.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Zinc Plug N Plate Dark Streaks/Coverage Capacity Questions | ms042180 | Electroplating Questions | 3 | 12-21-2006 11:48 AM |
| CopyCad & Zinc failure - electrolyte problems? | seanc | Electroplating Questions | 4 | 11-08-2004 09:16 AM |
| zinc plate and cad plate removal | fxstcguy98 | Electroplating Questions | 0 | 03-01-2004 11:46 PM |
| zinc plate nuts&bolts during restoration (quickly) | mikeyr | Electroplating Questions | 0 | 02-17-2004 02:55 AM |
| copper plate zinc came for stained glass? | gronos | Electroplating Questions | 1 | 12-14-2003 07:16 PM |
Linear Mode
