|
|
|||||||
| Notices |
| Metal Polishing Questions Discussion Board For metal polishing questions. |
 |
|
|
Thread Tools | Display Modes |
04-18-2006, 06:30 PM
|
|||
|
|||
Polishing Questions
Hello,
I'm looking into getting a part of mine polished instead of chromed (link below). I have a problem though, my welds have small pits and bumps in them. Is there something that can be put over/in them that can be polished? if not, what can i do? Link to pictures http://community.webshots.com/album/548933779TAFlBP I want the bracket, elbow and backplate of the cone polished, not the cone itself. Luke 
|
|
04-18-2006, 06:45 PM
|
|||
|
|||
|
Re: Polishing Questions
Any "bumps" could be ground out with cartridge rolls. You could get a nice clean radius around those connections with tapered rolls. You can't take _too_ much off, of course, so if there are deep pits, you're stuck with them.
Maybe fill them with a metallic filler. If you have it plated they could fill the pits with copper if you need a show finish.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| motorcycle polishing questions | shaybirde | Metal Polishing Questions | 3 | 04-30-2005 01:56 PM |
| Metal Polishing Questions for Nickel Plating | pelletman | Metal Polishing Questions | 3 | 07-31-2004 02:09 AM |
| lots of questions, polishing motorcycle frame | nopulse95 | Metal Polishing Questions | 10 | 02-11-2004 12:39 AM |
| Polishing Questions | 250R_Honda | Metal Polishing Questions | 6 | 01-06-2004 11:57 PM |
| A few polishing questions | scimitartoo | Metal Polishing Questions | 1 | 02-10-2003 02:34 PM |
Linear Mode
