|
|
|||||||
| Notices |
| Metal Polishing Questions Discussion Board For metal polishing questions. |
 |
|
|
Thread Tools | Display Modes |
10-21-2007, 06:25 PM
|
|||
|
|||
Where to get spacer kit for Baldor motor?
I picked up a used 1.5 HP - 3600rpm Baldor (410B - 7/8" shaft) buffing motor but it doesn't have the the metal washers/flanges?? (not sure what they are called). I have makeshift ones on there now but I can't get the 2" pad thickness and I think the correct pad holders are quite thin would allow me to do so.
Anyone know of a source? Thanks Last edited by bradnailer; 10-21-2007 at 06:49 PM. 
|
|
10-22-2007, 01:42 AM
|
||||
|
||||
|
Re: Where to get spacer kit for Baldor motor?
The wheel flanges are available from Baldor. The part number is HA6098 and cost about $12 each. The 410B only handles widths up to 1.25". If you want to go wider than that, you might have to make an adaptor.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Atv/dirt Bike Motor/case | Bigblock10 | Powder Coating Questions | 2 | 08-15-2007 03:26 PM |
| sandblasting dirtbike motor | nick9882 | Other Metal Finishing Questions | 2 | 10-29-2006 10:22 AM |
| motor housing | speeddemonrodsteration | Powder Coating Questions | 2 | 08-20-2006 11:54 AM |
| Motor cycle wheel | tavo1765 | Powder Coating Questions | 6 | 03-17-2005 10:44 PM |
| Electric motor to Polisher... | j__h | Metal Polishing Questions | 2 | 05-29-2003 04:23 PM |
Linear Mode
