stainless stiletto heels - Plating Powder Coating Buffing Anodizing

Rasper · #1 (**permalink**) 12-11-2007, 07:31 PM

Here's the latest from my sculpture studio. They are about four feet long. Mostly 22 and 24 ga. 304 stainless and 22 ga. cold rolled steel, with a little bar stock thrown in.

The most difficult part was beating those heels out of sheet metal. Stainless work hardens almost instantly. I hate the damn stuff, but I can't resist it; it's so gorgeous when you're finally done.

Richard

Jerm · #2 (**permalink**) 12-12-2007, 12:02 AM

Thats cool.

mpierich · #3 (**permalink**) 12-12-2007, 06:22 AM

Quote:

Originally Posted by Rasper

Here's the latest from my sculpture studio. They are about four feet long. Mostly 22 and 24 ga. 304 stainless and 22 ga. cold rolled steel, with a little bar stock thrown in.

The most difficult part was beating those heels out of sheet metal. Stainless work hardens almost instantly. I hate the damn stuff, but I can't resist it; it's so gorgeous when you're finally done.

Richard

Nice. Do you work in anything else, like brass?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
stainless polishing	jaclalo	Metal Polishing Questions	12	03-29-2007 08:37 PM
How to tell stainless?	mpierich	Metal Polishing Questions	7	06-19-2006 03:51 PM
Stainless	mpierich	Metal Polishing Questions	11	12-07-2005 08:57 AM
Stainless hardware	mudwhump	Anodizing Questions	5	01-12-2004 10:05 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)