![]() |
|
|
||||||
| Register | FlashChat | Blogs | FAQ | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
| Other Metal Finishing Questions Discussion board for any metal finishing questions not covered in the topics above. |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
For the use of a flash copper and nickel plate finish, I would think I need to get rid of the old nickel finish to get down to parent metal. |
|
|||
|
I believe pickle #1 (muratic) will remove the chrome, you make have to use the lead GP plates using pos on the club and neg on the GP. Use pickle #3 (sulfuric) to remove the nickle using the same method. If the nickle is in good condition, you could just activate the nickle with a 15 to 30 second dip in the pickle#3, rinse and either rechrome it or go straight to flash copper then nickle. I'm not sure if you can activate the nickle and nickle plate it directly or not, but the flash copper will stick to the nickle just as well as it does carbon steel.
|
![]() |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Silvaspray/Chrome/Brushed Nickel Finish on Plastic Part | vatik | Services Offered/Wanted | 2 | 07-29-2005 06:15 AM |
| Need to remove powdercoat finish. Please help | makneega | Powder Coating Questions | 4 | 11-30-2004 01:29 PM |
| Using a vibratory tumbler to refinish stainless golf clubs? | kenlancaster | Other Metal Finishing Questions | 1 | 12-10-2003 11:31 AM |
| Pot Metal Electroless Nickel - Suitability as finish | tgoode | Plating Pot Metal | 6 | 06-17-2003 08:01 PM |
| matte nickel finish | bmason | Electroplating Questions | 2 | 02-04-2003 12:14 PM |