Anyone Looking To Build Like This One? - Page 2 - Plating Powder Coating Buffing Anodizing

hvac60441 · #11 (**permalink**) 01-10-2006, 11:42 PM

the angle u can buy at a local hvac supply its 2x2x96 inches and the stat is from a standard oven mouted in the middle 1 inch off the wall it is within 25 degrees of being accurate.

DJuanHouston · #12 (**permalink**) 01-12-2006, 04:12 PM

Quote:

Originally Posted by hvac60441

the angle u can buy at a local hvac supply its 2x2x96 inches and the stat is from a standard oven mouted in the middle 1 inch off the wall it is within 25 degrees of being accurate.

Im considering trying to make 1 like the refridge I just read over but cost wise what does your design run on materials?

and as a circulation question will holes along the bottom and top both allow heat to flow as well as gas escape or do you really need a fan to criculate the heat?

UnorthodoxCreations · #13 (**permalink**) 01-30-2006, 08:43 PM

Quote:

Originally Posted by caswell

I don't see any insulation? Any reason for that?

I'm wondering as well, I'd like to build a decent size oven soon.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need to build fluidized bed	sagoland	Powder Coating Questions	3	04-07-2005 05:27 PM
i want to build an oven	suprtong	Powder Coating Questions	4	03-11-2005 01:43 AM
compound build up	chrisk	Metal Polishing Questions	5	07-11-2004 12:32 PM
Plate Build Up	crawfish96	Other Metal Finishing Questions	1	02-15-2004 05:20 AM
How to build an oven	Sezer	Oven Building Forum	2	12-24-2003 03:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)