|
|
|||||||
| Notices |
| Oven Building Forum Building A Curing Oven? - Here's the place to post your questions, specs and ideas. |
 |
|
|
Thread Tools | Display Modes |
02-02-2006, 01:44 AM
|
|||
|
|||
110 Oven ?
I found this forum the other day and I have been reading alot trying to gather information on building and oven. I read through almost all of the topics but did not see any information or discussion on building a 110 volt oven. Has anyone done it ? I tried searching ebay and could not find any home ovens or heating elements that could run on the 110 voltage that I have available in my garage.
|
|
02-02-2006, 05:16 PM
|
||||
|
||||
|
Re: 110 Oven ?
I built one using two elements from McMaster-Carr. They have a good selection, I used a couple of 1500 watt 110V bendable elements in a 48" X 28" X 36" (outside) oven that I built out of aluminum and 3-5/8 wide metal studs and tracks, with fiberglass insulation in between. It works great so far, no fires or meltdowns. I talked about it in a thread called "Building an oven using metal studs and aluminum" or something like that.
Steve Last edited by sdold; 02-02-2006 at 05:21 PM.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cooking up an oven project... | dagobert | Powder Coating Questions | 33 | 06-09-2008 03:43 PM |
| advice on oven propane or electric | RCC | Powder Coating Questions | 13 | 11-26-2006 09:57 PM |
| Oven problem !!!!! | tavo1765 | Powder Coating Questions | 7 | 10-06-2005 05:21 PM |
| Newbie and oven temperature ? | Netnut | Powder Coating Questions | 2 | 05-26-2005 09:49 PM |
Linear Mode
