|
|
|||||||
| Notices |
| Oven Building Forum Building A Curing Oven? - Here's the place to post your questions, specs and ideas. |
 |
|
|
Thread Tools | Display Modes |
03-13-2007, 06:11 PM
|
|||
|
|||
type j or type k thermocouple
just purchased controller/contactor and vendor wanted to know if i wanted type j or type k thermocouple.what the difference and which do i want....if it matters,i'm building with steel studs.......thanks.....will
|
|
03-13-2007, 07:08 PM
|
||||
|
||||
|
Re: type j or type k thermocouple
I need the education as well. So go give this a read. It should give you something to go by.
Sounds like K is the better of the two. Maybe not? http://en.wikipedia.org/wiki/Thermocouple
__________________
Who says you can't teach an ole dog new tricks? 
Last edited by JTW37; 03-13-2007 at 07:13 PM.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| type of element | baz | Oven Building Forum | 5 | 07-10-2006 07:43 PM |
| Type III (hard coating)? | xtal01 | Anodizing Questions | 5 | 01-11-2005 11:05 PM |
| what type of powder to use? | hybred | Powder Coating Questions | 6 | 06-24-2004 09:45 AM |
| how do i know what type of blasting material to use? | 11111111 | Powder Coating Questions | 26 | 11-28-2003 12:34 AM |
| How do I Hardcoat Anodize (Type III)? | 00_buckshot | Anodizing Questions | 2 | 09-09-2003 01:10 AM |
Linear Mode
