|
|
|||||||
| Notices |
| Oven Building Forum Building A Curing Oven? - Here's the place to post your questions, specs and ideas. |
 |
|
|
Thread Tools | Display Modes |
12-29-2007, 02:56 PM
|
|||
|
|||
gas oven questions
I have an old gas oven sitting around that i want to use for pc'ing. The open flame is covered by sheetmetal with about 10 half inch holes drilled in it. The air is drawn out through a duct at the top. Would this be safe to use and if it isn't then why? What if i covered the holes up to make sure no powder clouds got to the open flame? Also could i hook this oven up to a propane tank? any other suggestions would be very much appreciated.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| oven questions | Gyrocopter1 | Oven Building Forum | 5 | 01-30-2007 10:43 AM |
| oven questions | Gyrocopter1 | Oven Building Forum | 0 | 01-15-2007 09:46 PM |
| More oven questions.....? | wamontgomery | Oven Building Forum | 0 | 03-26-2006 07:42 AM |
| oven questions | tavo1765 | Powder Coating Questions | 2 | 03-03-2005 09:30 PM |
| Hi new to board and have a few oven questions | chicagorich | Powder Coating Questions | 4 | 12-30-2004 07:08 AM |
Linear Mode
