|
|
|||||||
| Notices |
| Oven Building Forum Building A Curing Oven? - Here's the place to post your questions, specs and ideas. |
 |
|
|
Thread Tools | Display Modes |
01-15-2008, 10:57 AM
|
|||
|
|||
Re: Question About sheet metal
Well after looking around a little, and then looking at the omega website i think im going to go with there 50a integrated heatsink SSR.
http://www.omega.com/ppt/pptsc.asp?r...660&Nav=autm01 the biggest thing that caught my eye was its auto shut off feature if it gets to hot. It seems like something worth having rather then frying one by mistake on a hot summer day since im working in a unfinished basement. So unless anyone has any objections to that SSR, i think that takes care of things for the moment. Once i start building im sure ill have more questions, but for now thanks a lot for the help. Its nice to have a good forum community to go to when you have questions. Thanks, Keith 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What gauge sheet metal? | questor | Oven Building Forum | 2 | 12-15-2007 12:05 PM |
| polishing thin sheet metal | Rasper | Metal Polishing Questions | 3 | 09-15-2006 09:29 AM |
| is galv sheet metal safe to use? | craigcraig | Oven Building Forum | 3 | 03-25-2006 10:23 PM |
| Question on Sheet metal | lsw11 | Metal Polishing Questions | 2 | 12-11-2005 04:02 PM |
| I'm a noob trying to plate sheet metal | USARMYnoob | Electroplating Questions | 1 | 08-03-2005 09:34 PM |
Linear Mode
