|
|
|||||||
| Notices |
| Plating Pot Metal Plating this troublesome metal can be very challenging. If you have questions, tips or tricks about plating onto pot metal (zinc diecast), this is the place to post them. |
 |
|
|
Thread Tools | Display Modes |
01-23-2004, 08:34 PM
|
|||
|
|||
A couple carb plating questions
1) After zinc plating my carburetors and fresh water rinse I worry that some solution may still remain in small passages or fuel bowls and would contaminate the chromate solution. Would it be best to have a heated tank of fresh water and submerge to insure all is thoroughly removed?
2) To obtain the finish of a typical dichromate Holley carb would you add zinc brightener or not? I really don’t want to polish but need the carbs to look factory original. Sorry if these seem like redundant questions but I’ll be plating several sets of carbs in the next week or so and want the best results possible. Thanks Ken 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gold Tank Plating Questions | gofannon | Electroplating Questions | 0 | 01-18-2005 02:53 PM |
| Differet copper plating questions, plus copy chrome/ nickel? | krsimulis | Electroplating Questions | 1 | 07-26-2004 12:25 AM |
| Couple of questions... | Bobby-S | Electroplating Questions | 1 | 06-13-2004 04:34 PM |
| First time plating, some questions.... | vic valis | Electroplating Questions | 1 | 09-29-2003 05:39 PM |
| Questions on plating a flute | Hoomi | Electroplating Questions | 1 | 03-08-2003 10:16 AM |
Linear Mode
