|
|
|||||||
| Notices |
| Plating Pot Metal Plating this troublesome metal can be very challenging. If you have questions, tips or tricks about plating onto pot metal (zinc diecast), this is the place to post them. |
 |
|
|
Thread Tools | Display Modes |
02-03-2008, 07:51 PM
|
||||
|
||||
Re: Agitator
Depends on the kit size.
Go to an aquarium suppliers (pet shop etc.). get a fish tank external pump and make a bubbler up. I use watering system ridge risers as they are fairly solid and make a ring with 4 1mm holes in thetop surface. Using various barbed joiners, run out to the side of the tank and up to the top. Make sure you mount/hang the air pump higher than the tank so it won't syphon the tanks contents through the pump. 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| retrofitting an agitator | krymis | Powder Coating Questions | 3 | 05-30-2006 07:59 PM |
| Agitator that comes with copper kit. | plater12 | Electroplating Questions | 2 | 07-26-2004 04:03 PM |
| Boyu filter/agitator question | Sean_Galt | Electroplating Questions | 4 | 02-03-2004 01:30 PM |
Linear Mode
