|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
FREE POWDER COATING SYSTEM
Until 8/31 - Buy an HV System, Get a Regular PC System FREE! Two systems for the price of one! (Limited Time - US Customers Only)
| View Poll Results: Do you use a Powder Coating Thickness Gauage? | |||
| Yes |
   
|
0 | 0% |
| No |
  
|
0 | 0% |
| Voters: 0. You may not vote on this poll | |||
 |
|
|
Thread Tools | Display Modes |
05-05-2004, 09:56 AM
|
|||
|
|||
Powder Thickness Guage
Does anyone recommend the Powder Thickness Guage? Or I should say what is everyones opinion on the Powder Thickness Guage? I know it says the area you check "may" affect the characteristics of the cured film. Any comments appreciated.
|
|
05-06-2004, 03:07 PM
|
|||
|
|||
|
Gauge selection will be dependent on substrate material and physical properties andthe coating thickness target range. Ferrous, non ferrous, geometry, and tolerances will be your primary input information in a gauge search.
-Scott
__________________
J. Scott Moncrief Manager-Engineering, R&D Livingstone Coating Corporation
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tips and Tricks | non-stick | Powder Coating Questions | 27 | 11-11-2007 02:01 PM |
| powder coating over powder coat? | corybarta | Powder Coating Questions | 6 | 08-21-2006 08:15 AM |
| Finding a place to powder coat | RCLSolutions | Powder Coating Questions | 3 | 05-04-2005 09:42 PM |
| Gun spitting excess powder | pdeinc | Powder Coating Questions | 8 | 10-21-2004 03:21 PM |
| Laser printer = Powder Coat Printer? | tbloss001 | Powder Coating Questions | 11 | 08-30-2004 06:08 PM |
Linear Mode
