wire rims - Plating Powder Coating Buffing Anodizing

craigcraig · #1 (**permalink**) 07-02-2004, 08:46 PM

whats the best way to go about PC wire rims? do you have to remove the spokes? also can you PC glass?

warchild · #2 (**permalink**) 07-03-2004, 04:23 AM

No. i leave the spokes in. but it is hard to get the powder to get on all of the spokes. i have to do the spoke rimes 2 times to get it to take the powder on all of them. And im lost on the glass. well i guess you could powder the glass if you heat it first to get the powder to take hold. I got powder stuck all over my ovens glass window.

craigcraig · #3 (**permalink**) 07-03-2004, 12:38 PM

thanks. i was hoping i didnt have to remove them. nothin but problems when you take them apart.

bzer1 · #4 (**permalink**) 07-03-2004, 08:05 PM

Yes you can powder coat glass.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Precision Wire Placement with a CDW	Fibergeek	Anodizing Questions	4	11-25-2004 11:07 PM
Does copper wire react with Zincated Aluminum??	krsimulis	Electroplating Questions	2	07-01-2004 09:51 PM
Shiny new rims	Josh	Metal Polishing Questions	3	02-05-2004 01:07 PM
Series 1100 Aluminum Wire	Fibergeek	Anodizing Questions	2	01-27-2004 12:29 PM
compressor question	duke	Powder Coating Questions	35	12-04-2003 11:20 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)