|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
FREE POWDER COATING SYSTEM
Until 9/15 - Buy an HV System, Get a Regular PC System FREE! Two systems for the price of one! (Limited Time - US Customers Only)
 |
|
|
Thread Tools | Display Modes |
09-06-2004, 07:16 PM
|
|||
|
|||
masking
Hello all,
I'm new to PC, (actually am just getting ready to do my first few practice parts), but learning alot from this forum. When I ordered my gun and powder from Caswell, I forgot to order the masking tape. My question is, why couldn't I just mask with regular tape, and remove it before baking? Thanks, Wolf 
|
|
09-07-2004, 01:09 AM
|
|||
|
|||
|
The powder (near the taped area) may be disturbed by removing regular masking tape. You're best off with the high-temp tape, then peeling it off after you cure.
|
|
09-10-2004, 09:24 AM
|
||||
|
||||
|
Ive been playing around with that chrome colored muffler tape, actually i believe it is used or use to be used in duct work, its metal faced with a sticky backing on it. so far its worked for doing some designs.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Masking products? | SX Paintball | Anodizing Questions | 4 | 02-14-2007 12:59 AM |
| Is thin sheet acrylic ok for masking? | ld2222 | Electroplating Questions | 1 | 12-15-2004 10:29 PM |
| Looking for a MASKING product for blasting ops | Halliwell1 | Other Metal Finishing Questions | 3 | 04-21-2004 07:23 PM |
| Masking products for EN plating? | edclark | Electroplating Questions | 0 | 12-23-2003 03:41 PM |
| Looking for masking tape recomendations. | chcarver | Metal Polishing Questions | 0 | 03-06-2003 02:51 PM |
Linear Mode
