Improve the flow of the hobby gun...

[Zpider]

Has anyone attempt to improve the flow of the hobby gun? I have problems with "hard to reach" areas such as complexed wheels and similar. Always tend to get thicker on some areas than other and its visible on the end result. I have played with the different nozzles but still not the flow i would like. So, anyone done any further tricks to the gun?

[jtagger19]

I made 4 1/8 holes to the small plastic tip
it works better for deep areas

[Popeye]

I've had the best luck without a tip. Spray in a lot of tight corners without a problem.

[kchotboat]

I have a attachment a guy made and sold them on ebay. It works real well. I will see if I have a pic of it.

[Zpider]

Thanks, would be nice to see some other solutions on the tip...

[KZjim]

I read in a diffrent thread about removing the tip, i tried it and it worked great. I did notice a diffrence in the amount of material flowing and the tighter pattern. I had to move farther away from the part and move the gun a bit more quickly around the part due to the increase amount of material.
But i think i will try the holes in the tip too, wont hurt to try.

[mtnbiker]

Add me to the list of removing the tip for tight areas.

[hulk30]

great result for the holley carb whithout the tips
shooting the powder at 36 inch from the piece at 7 psi
cover deep part on 2 strokes

[mtumbleson]

36" from the part? I would guess you mean 3-6 inches....

[machone]

The only time I use the tips anymore is for large area parts.
mach