|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
 |
|
|
Thread Tools | Display Modes |
03-26-2006, 12:53 AM
|
|||
|
|||
Outgas question
I understand what outgassing is and how to do it. But my question is this if I outgas a part can I then leave it for a few days before I powder coat it and it will be fine? Or do I have to outgas again?
|
|
03-26-2006, 11:43 AM
|
||||
|
||||
|
Re: Outgas question
It should be fine just make sure you keep it in a clean area until your ready to PC and make sure no one touches it with bare hands. If you have to go back through the cleaning process it will need outgassing again.
Jason www.autocyclepc.com
|
|
03-26-2006, 09:12 PM
|
|||
|
|||
|
Re: Outgas question
what kind of metal are we talking about? and how are you cleaning it? If you can't coat it right after outgasing Id jst hold of and do it all at once.
as Jason said it SHOLD be fine jst keep it clean.
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| To chrome or to powdercoat; that is the question... | dagobert | Powder Coating Questions | 4 | 12-21-2004 12:18 AM |
| Ovens with gas question | getastro | Powder Coating Questions | 22 | 11-08-2004 12:06 PM |
| Nickle "Plug-N-Plate" question HELP!! | pyro1711 | Electroplating Questions | 1 | 08-03-2004 09:29 PM |
| Peak voltage question | mudwhump | Anodizing Questions | 6 | 01-14-2004 10:53 PM |
| Brand Newbie Aluminum Polishing Question | gdsegel | Metal Polishing Questions | 1 | 04-25-2003 08:04 AM |
Linear Mode
