My new booth...

[DriKote]

I built this over the weekend...haven't had the chance to try it out yet though as my oven took a ****. Anyways, check out the pics and your comments are always welcome.

[DriKote]

more pics...

[DriKote]

yet more...

[JeffL]

And still room for the car.....sweeet.Wish I had room for something like that.

[wamontgomery]

Very nice...but I'm wondering, does that shop vac provide enough sucking power to get the excess powder out of the booth?

[FSTFBDY]

Id hope the shop Vac would. They suck up good. Its been along while since Ive used a Hobby gun but do they waste that much powder to fill that booth with dust?

[kchotboat]

I had a booth about that size. Cleaning it is a job. I did mine is sheet rock and then tried plastic. The plastic sheets where great to hose off. I ended up going smaller again since I really wanted the space back.

[DriKote]

I am not sure if the shop vac will pull the excess powder or not because I have yet to shoot anything in the booth yet...my oven died so I have pick up a new one before I can shoot anything. If the shopvac doesn't pull enough then I plan on installing a small fan or something in the vent to help pull the air out of the booth. I imagine it will be a PITA to clean but hopefully most the excess powder will be captured by the vent system...I dunno tho.

Thanks for the comments guys.

[kchotboat]

I use a 1hp fan like people use for wood working running through three stages of powder coating filters on mine. My plan is to run a 2hp next after I pick up a better gun.