|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
 |
|
|
Thread Tools | Display Modes |
04-23-2006, 04:26 PM
|
|||
|
|||
when to hang part
my oven is a preg 5ftx3ft its very hot when reaches the 400 degrees ,can i hang my part and then heat the oven?
|
|
04-23-2006, 09:06 PM
|
|||
|
|||
|
Re: when to hang part
Yes you can, Just start the cure cycle when the part comes upto temp as normal.
Get some nomex gloves http://www.actiongear.com/cgi-bin/ta...90&M5.ctx=7890
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PLATING POT METAL............... | 48Buick | Plating Pot Metal | 31 | 08-29-2007 11:40 AM |
| removing zinc | modadds | Electroplating Questions | 4 | 04-11-2005 01:13 AM |
| OVEN | 11111111 | Powder Coating Questions | 18 | 11-06-2004 03:16 PM |
| Part is 1/2 blue 4A, 1/2 Deep red. red fades when boiled | frubino | Anodizing Questions | 1 | 07-27-2004 01:56 PM |
| A few question to help a beginner | Cyberave68 | Anodizing Questions | 6 | 06-08-2004 08:53 PM |
Linear Mode
