High Temp problems. - Plating Powder Coating Buffing Anodizing

ctx97 · #1 (**permalink**) 12-24-2006, 07:10 PM

I just recently ordered some casewll high temp silver and black. Was doing a motor cycle canister. I don't know if you can do two differnent colors with high temp, figured it wouldn't be a problem. The base coat silver went on fine, applyed the decal I was used as a stenceil and shot the whole can in black. Let it flow out, pull it out of the oven and removed the decal and placed it back in the over.

Let it cure at 450 for 20 minutes. When we removed it from the over, the whole finished was cracking and flaking off, right out of the oven. It also did this on another piece I had in at the same time, that was just one coat of black. Anyone have any thoughts on why it did this?

cdaeme · #2 (**permalink**) 12-26-2006, 11:49 PM

I have had the same problems with high temp. From what I can tell you can't second coat with the high temp colors.

Jason

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems with tank temp	Slip666	Anodizing Questions	2	12-21-2006 12:46 AM
High Temp Ceramic powder	lfsracing	Powder Coating Questions	7	10-06-2006 11:10 AM
high temp sheeting	craigcraig	Powder Coating Questions	1	08-09-2004 12:15 AM
any experience w/ high temp on headers	RossL	Powder Coating Questions	2	05-05-2004 08:11 PM
Can I use VHT high Temp with Krylon High temp radiator paint	magnus	Other Metal Finishing Questions	1	05-03-2003 11:20 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)