|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
FREE POWDER COATING SYSTEM
Until 8/31 - Buy an HV System, Get a Regular PC System FREE! Two systems for the price of one! (Limited Time - US Customers Only)
 |
|
|
Thread Tools | Display Modes |
02-14-2007, 10:15 PM
|
|||
|
|||
just a little veiw of the eng.
here is the eng. before I actually bolted it together. I cann't seem to make a bigger picture.
Last edited by boston_jake01; 02-14-2007 at 10:17 PM. 
|
|
02-14-2007, 10:25 PM
|
|||
|
|||
|
Re: just a little veiw of the eng.
Here is the trans....
|
|
02-15-2007, 09:45 AM
|
|||
|
|||
|
Re: just a little veiw of the eng.
Looks great Rich. With all that powder on the jugs, have you thought about at least dry film lubricating the pistons? I most likely would have sprayed thermal dispersants on the heads, valve faces, and piston tops as well. Also ceramic the inside of the pipes to draw some of the extra heat away from the engine. This will most likely not be an issue during highway riding, but in stop and go traffic it could potentially cause some problems, if you put alot of miles on your bike in city driving conditions.
|
|
02-15-2007, 01:07 PM
|
|||
|
|||
|
Re: just a little veiw of the eng.
No I mostly drive in the suburbs and highway I hope I don't have a problem..
here is the pics I took today
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Powder coating motorcycle eng. | boston_jake01 | Powder Coating Questions | 6 | 10-28-2006 01:12 AM |
Linear Mode
