|
|
|||||||
| Notices |
| Powder Coating Questions Discussion Board For powder coating questions. |
 |
|
|
Thread Tools | Display Modes |
01-04-2008, 07:58 PM
|
|||
|
|||
Re: Powdercoating Plastic
Actually there is not much you can't powder coat if you have the correct equipment, I guess plastics like polycarbonate and nylon are the easiest to coat. I have also been reading about coating wood and found that most of the new office furniture is powder coated. From what I understand moisture is added to MDF to conduct the current, and I’m sure the voltages are much higher.
Check out http://www.powdercoating.org/wood/content.htm 
|
|
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Powdercoating help.... | Nirvanaib | Powder Coating Questions | 5 | 07-20-2006 10:59 AM |
| powdercoating over factory powdercoating | gestalt | Powder Coating Questions | 8 | 12-15-2005 01:08 AM |
| Having a go at powdercoating plastic...pics | Heavykote | Powder Coating Questions | 7 | 07-13-2005 09:48 PM |
| powdercoating plastic engine pieces | myillwillinc | Powder Coating Questions | 10 | 04-08-2005 06:58 PM |
| Powdercoating plastic | mystrwizard | Powder Coating Questions | 11 | 04-23-2004 08:38 AM |
Linear Mode
