valve covers - Plating Powder Coating Buffing Anodizing

jw450r1 · #1 (**permalink**) 01-18-2008, 07:24 PM

how is every-one shooting there valve covers.what are you holding them up with to shoot and cure?>......

precise · #2 (**permalink**) 01-18-2008, 09:40 PM

I just shoot my flat on the table and and slide them into the oven and set them on the oven racks like that

warchild · #3 (**permalink**) 01-19-2008, 04:00 PM

I do mine the same way as Jw450r1 does.

jw450r1 · #4 (**permalink**) 01-19-2008, 07:52 PM

hummmm.does any-one have any stands or something.if not.those shelves if powder coat gets on them and u reheat them will they burn off or what?....

JTW37 · #5 (**permalink**) 01-19-2008, 09:39 PM

I hang mine from either the oil hole or mounting hole. If you PC them on a rack and Bake them on the rack, it will also get cured and burning it off takes some heat and time. Try hanging them and see how it looks. Otherwise, I guess back to the racks. You could use coat hangers and make a hanger that would hang them level and try that and see how it looks for PC'ing.

jw450r1 · #6 (**permalink**) 01-20-2008, 07:42 AM

ok,thanks for the info...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mickey Thompson Valve Covers	asallwey	Powder Coating Questions	1	10-16-2007 10:35 PM
Harley Evo Rocker Covers	powdersparky	Powder Coating Questions	3	09-28-2007 12:20 PM
V-Max Aluminum Side Covers	buzzurd	Powder Coating Questions	1	10-21-2005 07:24 PM
intake manifolds and valve covers ?	upncoming	Anodizing Questions	5	03-20-2005 06:38 PM
valve covers	millerperformance	Powder Coating Questions	1	02-12-2005 01:08 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)