Announcement

Collapse
No announcement yet.

Just made 40 Titanium spring wire clips

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: Just made 40 Titanium spring wire clips

    That will work, they are about 1.5x1.25x.5 and a B%@#H to figure surface area on - semi rectagular with a 5/8" hole in them so hopefully this will work..........

    Destroyer25
    Thanks for all your help and Check your paypal and PM

    Comment


    • #17
      Re: Just made 40 Titanium spring wire clips

      Should work very good as long as you get a tight bend on them.
      www.125customs.com - Quality custom anodizing for simple and complicated jobs.

      Comment


      • #18
        Re: Just made 40 Titanium spring wire clips

        As for bending the titanium rod. Is it better to do it cold or should they be heated up. Or does it matter to make them spring back / out as much as possible?


        thanks again
        Ron

        Comment


        • #19
          Re: Just made 40 Titanium spring wire clips

          I cold bend.
          SS

          Comment


          • #20
            Re: Just made 40 Titanium spring wire clips

            I just made some for myself. I have this fancy wire bender, so I can make some accurate bends. If I remember to, I will post some pictures up tomorrow.
            www.125customs.com - Quality custom anodizing for simple and complicated jobs.

            Comment

            Working...
            X