Announcement

Collapse
No announcement yet.

NewB, just bought a buffer, will it work?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mtlgd
    replied
    I'm not a moderator, but I'll give it a shot.

    From the grinder description:
    Spindle: 5/8''-11

    From the Adapter description:
    This handy accessory fits a 5/8" shaft to extend the stubby shaft out 3" further from the motor body.

    As a Manufacturing Engineer, if only the major diameter of the thread is given, one should assume it is a coarse thread. Therefore the adapter most likely has a 5/8 - 11 thrd also.

    Be aware, the adapter appears to use 1/2 ID wheels.

    Leave a comment:


  • ellessone
    replied
    I know this forum doesn't get a lot of traffic, but can the moderators reply at least?

    Leave a comment:


  • ellessone
    started a topic NewB, just bought a buffer, will it work?

    NewB, just bought a buffer, will it work?

    Well, it's actually an angle grinder
    http://www.harborfreight.com/cpi/cta...emnumber=46507 w/ an 11 amp motor. I am going to also buy the grinder adaptor that Caswell sells. My question is, will the adaptor fit and will this setup properly polish the parts I want to on my car w/ Caswell's 6" wheels? Thx for your help
Working...
X