Announcement

Collapse
No announcement yet.

Optimum setup?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Optimum setup?

    Hello
    I am new to these forums and new at buffing and polishing. My uncle recently past away and left me the contents of his workshop. I am a very experienced woodworker but his shop was set up for metal machining and I am only moderately skilled with metal. Included in the equipment are three 3/4HP 1800RPM Baldor buffing motors. None of them have wheels on them. I would like to put a wire wheel on one but would like to know the optimum wheel and compound combination for the remaining 5 spots. Most of the buffing and polishing I will be doing will be for knife and tool repair. Any suggestions would be greatly appreciated.
Working...
X