Infra-Red Cure Option

[vemoo]

Is it not possible and perhaps preferred to use a propane driven infra-red heater as a better mousetrap over the now offerred and very expensive electrical plugins. I could fit the block in my oven, but think I could do well with a propane driven heater keeping the block on the engine stand. Is the water content of the generated heat a problem to curing the powder coat Vic

[corecoatings]

Infra-Red Cure Option

I would suggest using your oven. I started with a triple head ir heater and if you have a lot of time to kill that is the way to go. You have to watch it like a hawk and even then you may get under/over bake. I was trying to do mini sprint frames and you have to get at every angle and it really is a pain in the ass. 2 cents in, I'm out, Good luck!