Announcement

Collapse
No announcement yet.

Adjusting Temps and time

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adjusting Temps and time

    Lets say I had something that is not recommened to get above 300 and I wanted to PC it and the req for the powder is 400 / 10 min. What would the time be at 300 to get a proper cure?

  • #2
    I usually go 30 to 40 min at 300F depending on part mass and heat up speed.

    Comment


    • #3
      Thank a lot.

      Comment


      • #4
        Thanks Noob!! I'm assuming this question was asked for me?

        Kris

        Comment


        • #5
          Originally posted by remotestartdepot
          Thanks Noob!! I'm assuming this question was asked for me?

          Kris
          You are Correct

          Comment


          • #6
            Originally posted by Noob2PC
            Originally posted by remotestartdepot
            Thanks Noob!! I'm assuming this question was asked for me?

            Kris
            You are Correct
            Now to figure out how to disassemble the thing.

            Kris

            Comment


            • #7
              Originally posted by remotestartdepot
              Originally posted by Noob2PC
              Originally posted by remotestartdepot
              Thanks Noob!! I'm assuming this question was asked for me?

              Kris
              You are Correct
              Now to figure out how to disassemble the thing.

              Kris
              Crank up the boost to about 25 and let it run up to 7k, it will come apart

              Comment

              Working...
              X