Announcement

Collapse
No announcement yet.

Got a run in PC quick question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Got a run in PC quick question

    Trying to get into a corner I wound up building enough powder to get a run on a set of handlebars. Can I just and down that area and throw it in the oven quick to smooth it out or do I need to respray? Its not a super important job so if I have to respray I'll just leave it as is but if I can make the run less noticable I'd love to. The sooner someone can the respond the better, I'd love to get this piece finished tonight.

    Thanks,
    Adam
    Unorthodox Creations Powdercoating

  • #2
    Re: Got a run in PC quick question

    i have not done it but been told if the cure is right it can be sanded down(fine grit wet sanding) and then polished up like a car if you have a poliser or you can use a soft wheel on a buffer and some good paste wax.
    when in doubt polish it out/ why replace it when you can refinish it
    G2 Polishing and Powdercoating

    Comment


    • #3
      Re: Got a run in PC quick question

      That worked pretty well. It not perfect but I didnt work at it very hard at all. It on the underside of handle bars so the finish isnt super important but if I had worked at it harder I'm sure I could have gotten them nearly flawless.


      Thanks
      Adam
      Unorthodox Creations Powdercoating

      Comment

      Working...
      X