small Nickel plating job-any takers?

[wop1969]

I can repair and nickel plate the item you have.

I'm located in Florida and if you still need and are interested please go to my website and see my gallery of work I have done. There is also contact information there so you can get ahold of me.
http://www.leveinc.com

[dagobert]

Still needing it done?

Have you gotten the faucet replated yet? If not, how bad is the pitting? As the old saying goes, "you can't polish a turd", but if it's not too eaten up, I'd be willing to give it a shot. To get a satin finish, I can glass-bead blast it and then copper plate it, then nickel plate it without a lot of polishing inbetween. That should give it the texture it sounds like you are describing. Let me know here if you are interested. I'm in Columbia, TN (just south of Nashville).

Jay

[fxstcguy98]

OK
I am in Columbus OH. You might want to find someone closer, the shipping costs will make it expensive.
Thanks

[y2khardtop]

near Charlotte NC.

No, I want satin nickel over polished brass. The photo is an example of my fixture, but mine is currently brass!

Thanks

[fxstcguy98]

where are you located? Do you want chrome over the satin nickle?

[y2khardtop]

I have a tub faucet that I am intersted in getting plated in a satin Nickel finish. It is currently polished brass, and has a "pitts" in it. It is an expensive unit, and I would like to plate it instead of replacing, if possible.

Thanks

btw, it is about 8" long or so, and about 6.5" deep. I can get exact measurements